3.6 L Pentastar Camshaft Torque Specs. Star case a star case bulletin, s1309000016, was released just over two years ago (march 18, 2014) in regards to the rocker arms used in the pentastar® engine. Tighten bolts (2) to the proper (torque specifications).
2 from
This virtually eliminates the possibility of stretching the factory head bolts. It has dual overhead cams with four valves per cylinder (24 valves in total). Tighten bolts (4) to the proper (torque specifications).
A Short One And A Long One.
It used an aluminum block instead of iron to save weight. Tighten bolts (4) to the proper (torque specifications). Compare the measured end play to the specification.
Move The Camshaft Forward To The Limit Of Travel.
The last 2 are the center ones at the ends of the cover. Using the tightening sequence shown, tighten the bearing cap bolts to 10 n·m (89 in. Arp is the leader in engine fasteners.
This Virtually Eliminates The Possibility Of Stretching The Factory Head Bolts.
1) fca pentastar cylinder head failure. If removed, install the right side cam chain tensioner (3). Torque these bolts in a few small increments until they have reached 250 inch pounds of torque.
Be Careful, I Broke Two Valve Cover Bolts.
They manufactured specifically for prodigy performance a set of head studs for the 3.6 pentastar engine. It is also smaller in size: It has dual overhead cams with four valves per cylinder (24 valves in total).
Our 3.6 L Pentastar Engine Is Carefully Balanced, Bored And Honed Using Cylinder Torque Plate.
Repeat on the other camshaft. 94 mm shorter than the 3.7 and 34 mm than the 3.5 v6. This allows a lighter, cheaper, and.
Share
Post a Comment
for "3.6 L Pentastar Camshaft Torque Specs"
Post a Comment for "3.6 L Pentastar Camshaft Torque Specs"